Well mPBX-36 Dokumentacja Strona 118

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 145
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 117
WELL mPBX-U110R Administrator's Guide
Page118
APPENDIX C How to Configure
NAT setting
When mPBX is behind a NAT(firewall),you need to configure NAT
setting on mPBX if you want to use a remote extension.
Please follow section 1 or 2 below depending on your network configuration.
1. If mPBX is connected to a local network, you must set up port forwarding
on your router. Specifically, you must map port 5060 (default SIP port) and
port 10001-10200(default RTP port range) as UDP ports.
Next, go to the mPBX web interface and configurethe SIP settings according
to Figure C-1:
External IP Address: your router’s public IP address
External Host: your router’s domain
ExternalRefresh Interval: 20 seconds
Local Network Identification:192.168.5.0/255.255.255.0 (change this
according to your network configuration)
NAT mode: Yes
Allow RTP Reinvite: No
Figure C-1
Assuming that your router’s host address is yeastar.3322.org, your local
network is from 192.168.5.1-192.168.5.254, and the subnet Mask is
255.255.255.0, the mPBX network settings should configured like Figure
C-2
Przeglądanie stron 117
1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 144 145

Komentarze do niniejszej Instrukcji

Brak uwag